 | |||||
| Images | Schedule | About | Contact | Blog | Home |
Archive for February, 2010ICFF Video with New England Home MagazineTuesday, February 16th, 2010
My furniture was featured in a video produced by New England Home Magazine. This was their wrap-up of the ICFF show in NYC. In the Video, Kyle Hoepner and I are talking about my Convergence Coffee table. Kyle particulary enjoys the illusion of the glass top and the usage of parallam. I have been making Parallam furniture for a couple of years. It is a engineered lumber made from Poplar, Spruce and Southern Yellow Pine.
If you want to skip ahead, my piece starts at 2:24 into the clip.
New Furniture- Just back from the photographerFriday, February 5th, 2010I had a photo shoot yesterday with Tom Stock, my photographer in Saratoga Springs. I decided to go for a different look than I have been featuring with my furniture, and Tom expertly pulled it off. Here are the latest images and a sneak peak at two of the brand new designs I will be exhibiting this spring. First, the Helium dining table- made from jet black Mahogany, glass, woven stainless steel cable and a custom milled aluminum corner bracket.
Next the Torus pedestal table In Mahogany with concrete and stainless steel cable.
I also had him shoot an Axis bench with a dyed black Mahogany top rather than the Parallam top the original bench was built in.
Lastly the Convergence Coffee Table featuring Parallam and Mahogany.
Milling Aluminum Brackets for the Helium Dining TableWednesday, February 3rd, 2010After I built the Torus Pedestal table I was still intrigued by the possibilities of creating joinery by milling chunks of aluminum. In designing a new dining table I chose to use a similar technique to create the joint where the leg meets the stretcher. My first step was to mock up the bracket which I had drawn in my sketch book. The wood mock-up allows me to check proportions and really visualize the steps that are needed to create the bracket. I start with a large piece of aluminum It is 1 3/4″ thick, 8″ wide and 36″ long. Step one is cutting this massive chunk into more manageable pieces.
Then I am back at my horizontal mill precisely squaring the blocks. In this photo you can really see the coolant and chips flying everywhere! The blocks are measured with a large micrometer. The Blocks have been squared up and now the vise is rotated and I change the cutters. The heavy cutting is about to begin. The chips build up quickly. The grooves get cut and then the remaining triangles are removed with a saw. You can see the offcuts on the right side of this picture. Next I am off to the vertical mill. This machine, made by bridgeport, is more accurate, but less powerful than the horizontal mill. Here I will refine the surfaces created by the mill and saw. The cutting begins A smaller Micrometer is used to measure the thickness accurately. Things are looking good. The bottom corners are roughed out on a saw, then put back on the horizontal mill for finishing. Check out how the chip gets peeled off as the cutter just breaks the edge of the metal. The brackets are getting close. Time for some drilling and tapping. The through holes are drilled and countersunk. The rest of the holes are drilled and tapped. And finally the before and after on the scales. Almost 4 lbs of metal removed- about half the weight! Next stop, building the rest of the table. | |||||
